Maximum Nor'easter Manual do Utilizador

Consulte online ou descarregue Manual do Utilizador para Instrumentos de medida Maximum Nor'easter. Maximum Nor'easter User Manual [en] Manual do Utilizador

  • Descarregar
  • Adicionar aos meus manuais
  • Imprimir
  • Página
    / 4
  • Índice
  • MARCADORES
  • Avaliado. / 5. Com base em avaliações de clientes
Vista de página 0
NOR’EASTER
INSTALLATION
PROPER INSTALLATION IS IMPORTANT. IF YOU NEED ASSISTANCE, CONSULT A CONTRACTOR,
ELECTRICIAN OR TELEVISION ANTENNA INSTALLER (CHECK WITH YOUR LOCAL BUILDING SUPPLY
OR HARDWARE STORE FOR REFERALS). TO PROMOTE CONFIDENCE, PERFORM A TRIAL
WIRING BEFORE INSTALLATION.
1. Determine where you are going to locate both the rooftop sensor and the Nor’easter read-out.
There are lugs on the rooftop end of the 2-wire cable and bare ends on
the indoor connection. Run the cable from the indoor read-out, to the
rooftop wind speed generator.
2. Outside, feed the terminal lug end of the 2-wire cable through the
rubber boot and connect the lugs to the brass terminal posts on bottom
of the wind speed generator (polarity does not matter) and secure them
using the brass hex nuts provided in the hardware pack.
(Important: DO NOT adjust the hex nuts that are already on the sensor).
3. Slide the straight stub mast through
the rubber boot and insert the mast
into the bottom of the wind speed
generator. Secure the generator to
the straight stub mast using the
supplied cotter pin. Coat all wire
connections with a silicone sealant
and slip the boot over the sensor.
4. Using the two stainless steel hose
clamps, attach the straight stub
mast to an appropriate base mast
NOTE: For correct wind speed
readings, the generator should be
mounted a minimum of 8 feet above
your roof, as shown in the diagram.
5. Follow the instructions supplied with the antenna mount and secure the
mast to the mount.
6. Secure the cable to the mast with cable ties or electrical tape so that
rubbing on the mast will not damage it. Secure the wire to the house
using cable clips (DO NOT staple the cable). Form a drip loop where
the wire enters the hole through an exterior wall. Feed an appropriate
length of cable into the house and caulk the hole when done.
Vista de página 0
1 2 3 4

Resumo do Conteúdo

Página 1 - NOR’EASTER

NOR’EASTER INSTALLATION PROPER INSTALLATION IS IMPORTANT. IF YOU NEED ASSISTANCE, CONSULT A CONTRACTOR, ELECTRICIAN OR TELEVISION ANTENNA INSTALLER

Página 2

NOR’EASTER INSTALLATION (cont.) 7. Bring the Nor’easter read-out and the 2-wire rooftop cable to the location where you wish to install it. At the

Página 3

IMPORTANT ADDITIONAL INFORMATION Components: Along with the indicator, the following components are included with this instrument:

Página 4

30 SAMUEL BARNET BOULEVARD  NEW BEDFORD, MASSACHUSETTS 02745 U.S.A. TEL. 508.995.2200  WWW.MAXIMUM-INC.COM  FAX 800.989.2580 Electrical Damage

Comentários a estes Manuais

Sem comentários