Maximum Mystic Manual do Utilizador descarregar pdf

MYSTIC

INSTALLATION

PROPER INSTALLATION IS IMPORTANT. IF YOU NEED ASSISTANCE, CONSULT A CONTRACTOR, ELECTRICIAN

OR TELEVISION ANTENNA INSTALLER (CHECK WITH YOUR LOCAL BUILDING SUPPLY, OR HARDWARE STORE

FOR REFERRALS). TO PROMOTE CONFIDENCE, PERFORM A TRIAL WIRING BEFORE INSTALLATION.

30 Samuel Barnet Boulevard

New Bedford, MA 02745

(508) 995-2200

Connect the AC adapter to Mystic and plug into outlet. The display will

briefly light up all the indicator lights (self test). Next the display will show

the unit of measurement codes and then will show the barometer function

light and the center display will show a pressure reading. Leave Mystic in

this mode for two hours. Do not activate the switch at the bottom of

the case. At the end of this two hour period, Mystic will be ready to have

the pressure adjustment performed.

Form a drip loop with the wire at least eight inches

below the exit from the sensor and at least eight inches

below the point of entry into the building. Anchor any

exposed wire with insulated cable clips. Run the wire

through the building to the location where the indicator

will be located. Caulk any holes when done.

Unplug the AC adaptor and disconnect the wires. Mystic is now ready for the final installation.

The adjustment that you have made will always remain intact.

Now calibrate the barometer for your altitude. Obtain the current barometric

pressure for your area by calling a near-by airport or an individual who has a

properly set barometer. Insert a small screw driver into the recessed slotted

screw at the back of Mystic. Turn the screw while observing the pressure read

out on the front of Mystic. Due to the sensitivity of this adjustment, the numbers

on the display may fluctuate during this procedure. It may take a minute to

achieve the exact setting. Once the unit is set, move the toggle switch to the

right (auto) one time to lock in the setting.

Mount the temperature sensor assembly with the two

large wood screws. Select a location that is protected

from direct sunlight and sheltered from rain and physical

damage. (A north exposure, six feet above the ground

will give the best results.)

DRIP

LOOP

CAULK

CABLE

CLIP

MIN

1 2 3 4 5 6 7

Resumo do Conteúdo

Página 1 - INSTALLATION

MYSTICINSTALLATIONPROPER INSTALLATION IS IMPORTANT. IF YOU NEED ASSISTANCE, CONSULT A CONTRACTOR, ELECTRICIAN OR TELEVISION ANTENNA INSTALLER (CHECK

Página 2 - INSTALLATION (CONT.)

MYSTICINSTALLATION (CONT.)30 Samuel Barnet BoulevardNew Bedford, MA 02745(508) 995-2200Feed the cables from the AC adapter and the temperature sensor

Página 3 - OPERATION

MYSTICOPERATION30 Samuel Barnet BoulevardNew Bedford, MA 02745(508) 995-2200NOTE: After any "FULL" reset, temperature and/or wind chill dat

Página 4 - OPERATION (CONT.)

MYSTICOPERATION (CONT.)IMPORTANT FACTS ABOUT YOUR MYSTIC30 Samuel Barnet BoulevardNew Bedford, MA 02745(508) 995-2200Latch Up- Power Line disturbance

Página 5 - TROUBLESHOOTING

MYSTICTROUBLESHOOTING30 Samuel Barnet BoulevardNew Bedford, MA 02745(508) 995-2200If at any time the temperature reading seems to be giving you diffic

Página 6 - (508) 995-2200

MYSTICINFORMATION FOR THE MERLIN USER30 Samuel Barnet BoulevardNew Bedford, MA 02745(508) 995-2200Warning: Changes or modifications to this unit not e

Página 7

IMPORTANT ADDITIONAL INFORMATION Components: Along with the indicator, the following components are included with this instrument:

Comentários a estes Manuais

Sem comentários

Maximum Mystic Manual do Utilizador

Consulte online ou descarregue Manual do Utilizador para Instrumentos de medida Maximum Mystic. Maximum Mystic User Manual Manual do Utilizador

Resumo do Conteúdo

Comentários a estes Manuais

Manuais e produtos relacionados com Instrumentos de medida Maximum Mystic